Banana Pi如何编译Bootup u-boot

今天给大家介绍一下Banana Pi如何编译Bootup u-boot。文章的内容小编觉得不错，现在给大家分享一下，觉得有需要的朋友可以了解一下，希望对大家有所帮助，下面跟着小编的思路一起来阅读吧。

1. compile　u-boot
$ git clone git://github.com/linux-sunxi/u-boot-sunxi.git
$ make Cubieboard2_config
$ make
2. burn u-boot
$ dd if=/dev/zero of=/dev/sdb bs=1M count=1
$ dd if=u-boot-sunxi-with-spl.bin of=/dev/sdb bs=1024 seek=8
3. start u-boot

--->8---
U-Boot SPL 2014.04-rc2-10390-g96510e1 (Apr 04 2014 - 21:11:38)
Board: Cubieboard2
DRAM: 1024 MiB
CPU: 960000000Hz, AXI/AHB/APB: 3/2/2
spl: not an uImage at 1600


U-Boot 2014.04-rc2-10390-g96510e1 (Apr 04 2014 - 21:11:38) Allwinner Technology

CPU: Allwinner A20 (SUN7I)
Board: Cubieboard2
I2C: ready
DRAM: 1 GiB
MMC: SUNXI SD/MMC: 0
*** Warning - bad CRC, using default environment

In: serial
Out: serial
Err: serial
Net: Phy not found
dwmac.1c50000
Warning: failed to set MAC address

Hit any key to stop autoboot: 0

以上就是Banana Pi如何编译Bootup u-boot的全部内容了，更多与Banana Pi如何编译Bootup u-boot相关的内容可以搜索之前的文章或者浏览下面的文章进行学习哈！相信小编会给大家增添更多知识,希望大家能够支持一下！